Freecom Internal IDE, Руководство пользователя

Страница: 17 / 31

2.2 Jumper Set Up
Before installation, set the jumper on the jumper connector on the rear panel.
The drive can be connected as the Master or Slave on an (ATAPI) interface.
When several (up to four) devices are connected, each must be set in a
unique way. Specific knowledge of hardware and software is necessaryto install
the drive.
We cannot guaranty against direct or indirect damage resulting from improper
connections. Ask your supplier for details of the installation procedure.
Attantion! If two peripheral devices with the same settings are both connected
to the Primary or to the Secondary
bus, the host computer may fail to run,
or may malfunction, so careful attention is necessary.
CS: Cable Select
Make sure that the host computer is turned OFF when connecting or removing
a jumper.
Connect the jumper in the vertical direction as shown in Figure 1. If connected
horizontally as shown in Figure 2, the drive may malfunction or be damaged.
Figure 1.
(Master setting)
Figure 2.
Attantion! Only one jumper should be installed on the jumper connector. If
more than ne jumper is installed, the drive may malfunction or be damaged.