FOOTSWITCH FUNCTION SWAPPING
TAP-PREFERRED MODE
In Tap-Preferred mode, the preset is recalled by applying the tempo information lastly entered via the footswitch. For
example, if you change presets after entering the tempo by tapping at the beginning of a piece (tune), the tempo
information remains unchanged. You don’t have to perform a Tap-entering again.
In Preset-Preferred mode (usual mode), BPM and delay time values stored in the recalled preset will be recalled.
<How to Setup>
Press and hold down the
ON/OFF-STOP
and
TAP-PLAY
footswitches for about three seconds to switch the modes.
When in Tap-Preferred mode the
TIME
display shows [
TAP
]. When in Preset-Preferred mode (usual mode) the display
shows “PrST”.
The FT-1Y can swap the
TAP-PLAY
and
HOLD (REC)
footswitches physically. For example, you can use the
HOLD
(REC)
footswitch connected to the terminal on the rear panel when you want to enter a Tapped tempo. Or, according to
your application, while keeping the main unit of the FT-1Y on the pedal board, you can place the footswitch for tap-enter
operation at a place where you can easily step on it.
<How to Setup>
To swap the functions, press and hold both the
TAP-PLAY
and
HOLD (REC)
footswitches for about three seconds.
When the
TAP-PLAY
footswitch is set to act as a HOLD (REC) switch, the
TIME
display shows [
Hold
]. When the
TAP-
PLAY
footswitch is reset to its default TAP-PLAY switch function, the
TIME
display shows [
TAP
].
INITIALIZING
If you need to reset your FT-1Y to its default status when shipped from the factory, use this Initializing function.
While holding down both the
INC/+
and
DEC/–
switches in the Parameter Edit section, turn on the power to the FT-1Y.
Doing this clears all of the presets and returns the unit to its factory shipment status.
FACTORY PRESETS
MIDI SPECIFICATIONS
Presets stored in the factory preset region 91–99 cannot be overwritten. For the contents of the presets, please refer to
the Free The Tone web site.
Controls
MIDI CC Numbers
Value Range
DELAY LEVEL
81
0–99
FEEDBACK (0–99)
82
0–99
FEEDBACK (1.1–9.9)
83
11–99
OUTPUT LEVEL
84
10–99
LPF
21
off = 0, 22k = 22, 20k = 20, 18k = 18, 16k = 16, 14k = 14,
13k = 13, 12k = 12, 11k = 11, 10k = 10, 9k = 9, 8k = 8,
7k = 7, 6k =
6, 5k = 5, 4k = 4, 3k = 3, 2k = 2, 1k = 1
HPF
22
off = 0, 20Hz = 2, 40Hz = 4, 50Hz = 5, 60Hz = 6, 80Hz = 8,
100Hz = 10, 120Hz = 12, 140Hz = 14, 160Hz = 16, 180Hz = 18,
200Hz = 20, 250Hz = 25, 300Hz = 30, 400Hz = 40, 500Hz = 50,
600Hz = 60, 700Hz = 70, 800Hz = 80, 900Hz = 90, 1k = 99
RATE-UP
31
off = 0, 1–99
RATE-DOWN
32
off = 0, 1–99
DEPTH
33
off = 0, 1–99
SUBDIVISION
41
Whole note = 1, Half note = 2, Dotted Quarter note = 3, Triplet in
four = 4, Quarter note = 5, Dotted Eighth note = 6, Triplet in two =
7, Eighth note = 8, Triplet in one = 9, Sixteenth note = 10
OFFSET (+)
42
0–99
OFFSET (–)
43
0–99
TRAIL
51
off = 0, on = 127
REC & REPEAT MODE
52
off = 0, on = 127
BPM ANALYZER
53
off = 0, on = 127
DELAY PHASE
54
off = 0, on = 127
EFFECT ON/OFF
61
off = 0, on = 127
TAP
62
on = 127
HOLD
63
off = 0, on = 127
PLAY
71
127
REC
72
127
STOP
73
127
Содержание FT-1Y
Страница 1: ...OWNER S MANUAL Ver 1 0...