FRC TankVisionPro WLA300, Руководство пользователя

Страница: 16 / 44

WLA300 Rev170606
16
3. Wait 5 seconds to enter the program.
4. Each swipe changes the LEDs brightness—ten levels that are stepped through
and then repeated.
5. Hold the magnet over the calibration point for five seconds to load the new
setting. The display blinks three times to confirm setting is loaded.
Programming the MaxVision to Display Foam A, Foam B or Water:
Code Entry:
● Hold a magnet over the calibration point for five seconds. Two middle rows
of LEDs come on.
Swipe 4 times
to set the display for one of the following options:
● Water (Default option)—displays alternate Blue LEDs
● Foam A—displays alternate Green LEDs
● Foam B—displays alternate Yellow LEDs
1. Wait 5 seconds to enter the program.
2. Each swipe changes the choice from Water, to Foam A, to Foam B—the three
options are stepped through and then repeated.
3. Hold the magnet over the calibration point for five seconds to load and save the
new setting. The display flashes or blinks three times to confirm setting is saved
and updated.
Programming the Color Pattern for the MaxVision:
The default setting for the color pattern is to have this synchronized with the primary
display (as described on page 29, Fig. 10). If it is required to have the MaxVision synchronize
with the primary display, activate the "Code Entry" (as mentioned on page 15), select Pattern
#10, wait for 5 seconds and swipe the magnet once
.
Save the setting by holding the magnet
for 5 seconds at the calibration point.
However, these same six color patterns from Fig. 10 (shown in Fig. 5) can be "locked
in" for the MaxVision only, separately from the color pattern shown on the primary display.
Additionally, there are three color patterns to display the status level of either Foam A
(all Green LEDs) , Foam B (all Yellow LEDs) or Water (all Blue LEDs). This allows for
customizing of up to nine different "locked-in" color patterns on the MaxVision display
(separate from the primary display).
Perform the following steps to select the locked in color pattern for the MaxVision:
1. Start the "Code Entry" by holding the magnet the calibration point for five seconds.
Two middle rows of LEDs come on.
2. Swipe the magnet to select the program to be changed; a row of LEDs come on
with each swipe.