2
SAFETY PRECAUTIONS
It is the owner
’s responsibility to instruct all equipment operators
and support personnel in the operation of machine.
Do not operate this machine until the owner’s manual has been
completely read and understood. New owner’s manual are
available from your dealer or the factory phone + 45 98 63 21 22.
All screens must be correctly positioned and checked before the
machine is started. It is dangerous to remain in the machine's
working area while its working parts are rotating. Keep hands, feet
and clothing away from power driven parts! Do not leave the tractor
running unattended.
Disengage the PTO and turn the tractor off before you service the
machine.
The machine is made to work in hay and straw crops, and may not
be used for anything else.
The machine may only be operated by qualified operator.
Familiarize yourself with the controls and how to stop the machine
and tractor in an emergency.
Do not let children or incapable persons operate the machine.
Machine lubrication, adjustment and setting may only take place
while the machine is not in use and while the power take-off is
switched off.
Remove the keys so the tractor cannot be started up accidentally.
Retighten bolts and check adjustments after approx. 5 hours of
operation.
Only use original Fransgård spare parts.
INTRODUCTION
The Fransgård Combirake model TI-6000 is one of the fastest and
most effective combirakes on the global market, and has all the
working functions. A combirake which can rake into central, side
and double swaths, as well as being able to spread.
For tedding, the rake arms are in the locked position, and the
machine leans forward to level the material evenly.
For raking up, the rake arms are cam-track controlled so in the fact
that the tines tilt upwards, allowing the material to be treated very
gently.
The rake high can be set by raising or lowering the wheels by
means of a bolt (41431). The rake should be stopped and raissed
using the tractor lift before this adjustment is made.
When driving with the top-link attachment in floating position, the
bolt (42400) has to be removed and the top bar adjusted as shown
in the illustration.
The machine is fitted with balloon tyres with a wide bearing
surface.
The rotor speed and forward speed of the tractor must be selected
on the basis of the type and state of the crop.
PTO:
Tedding and turning over, 400-max. 500 rpm.
PTO:
Raking up, 350-max. 400 rpm.
ASSEMBLY
Mount the intermediate frame (42407) on the main frame (42508)
with bolt (42413), then mount the cotter (741190285) and the bolt
(42452) with cotter pin (1210075), after which mount three-point
suspension (42505) on intermediate frame (42407) with bolt
(42506) and cotter (741190155).
Mount the top-link attachment (40401) on the three-point
suspension (42505) with bolt (41463), bolt (42400) and cotter pin
(1210075).
Mount support leg (42404) with bolt (15558) and split pin
(1220040).
Mount cylinder (42411) with bolts (42412) and cotter (741190215).
Mount the wheel, which are assembled complete with mounting, on
the machine with bolt (41431) and cotter pin (1210060).
Now mount hydraulic hose (42417) on small cylinder (42411) with
hexagon nipple (42419) and copper washer (42418).
Figure 1: Remember to
tighten bolts
Figure 2: Remember to tighten
chains
