Franke 3590040 FSBS 6001 N ID XS A+, Руководство пользователя и инструкция по установке, Страница: 24 / 74

en en
Replacing Freezer Door
Insert the water tube into the hole of
the bottom hinge pin first (Dispenser
Models Only). Insert the bottom of
freezer door into the bottom hinge pin. Insert the bottom hole of freezer door
straight to the bottom hinge pin. Let the top of door close to the
cabinet and insert the top hinge pin
to the top hole of freezer door. (Insert
the back of hinge to the groove of
protrusion first, then front to the top
hole of door.)
Turn the hinge fastener tightly to the
end. Connect harness wirings and
screw ground wire.
Insert the water tube far into the
coupling.
(Dispenser Models Only)
Replacing Refrigerator Door
Insert the bottom hole of refrigerator
door straight to the bottom hinge pin
Let the top of door close to the cabinet
and insert the top hinge pin to the top
hole of freezer door. (Insert the back of
hinge to the groove of protrusion first,
then front to the top hole of door.)
Turn the hinge fastener tightly to the
end. Connect harness wirings and
screw ground wire. Click and screw
the top hinge cover.
Refrigerator Leveling & Door
Adjustment (If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
In case freezer door is lower than refrigerator door...
Insert a screw driver (flat tip) into a groove of the left wheel (bottom of freezer) and
turn it clockwise until the door is balanced.
(clockwise to raise freezer door ; counterclockwise to lower)
In case refrigerator door is lower than freezer door...
Insert a screw driver (flat tip) into a groove of the right wheel (bottom of refrigerator)
and turn it clockwise until the door is balanced.
(clockwise to raise refrigerator door ; counterclockwise to lower)
Front Cover
After installation and/or door leveling, fasten front cover with screws.
(Remove the screws on the front bottom panel first. Click and screw the cover)
The front of refrigerator needs to be higher just a little than the back for easy door closing, but if
the wheel is raised too much for door balance, i.e. front of refrigerator is higher than the back, it
can be difficult to open thedoor.
Caution
45 44