
35
Adjust the stays upward and downward by rotating them.
After maintaining the balance, compress the plastic adjustment nut upward again.
Never put cardboard, wood or suchlike materials under your machine if you are intending to stabilize the
distortions on the ground.
When cleaning the ground, on which your machine rests, be careful not to disorder stays stabilization.
ELECTRICAL CONNECTION
•
Your washing machine is set to 220-240V and 50Hz.
•
The mains cord of your washing machine is equipped with a specific earthed plug. This plug should
always be inserted to an earthed socket of 10 amps.
•
The current value of the fuse should be 10 amps. Fuse current value of the power line connected to
this plug should also be 10 amperes.
•
If you do not have such a receptacle and fuse confirming with this, please have it done by a qualified
electrician.
•
We do not take the responsibility of the damages that occur due to ungrounded usage.
NOTE: Operating your machine under low voltage will cause the life cycle of your machine to be reduced
and its performance to be restricted.
WATER INLET HOSE CONNECTION
•
Your machine may have either a single inlet (cold) or double water inlets (cold/hot) based on its
specifications. White-capped hose should be connected to cold water inlet and red-capped hose to hot
water inlet (applicable for machines with double water inlets).
•
To eliminate water leakages in points of contact, 1 or 2 nuts are provided in the hose package (applicable
for machines with double water inlets). Fit these nuts to the ends of new water inlet hoses on the side of
faucet.
•
Mount new water inlet hoses to a ¾ ˝, threaded faucet.
•
Connect the white-elbow end of the water inlet hoses to the white-filtered water inlet valve on the rear
side of the machine and the red-elbow end to red-filtered one (applicable for machines with double
water inlets). Tighten plastic parts of the junctions using your hand. In uncertain conditions, have the
connection works be done by a qualified plumber.
•
Flow of water with pressure of 0,1-1 Mpa will allow your machine to operate more efficiently.) (0,1 Mpa
pressure means that more than 8 liters of water will flow through a fully tapped faucet per one minute.)
•
Ensure that points of contact do not leak by tapping the faucet completely after carrying making the
connections.
•
Ensure that the new water inlet hoses are not bent, broken, crushed and resized.
•
If your machine has double hot water inlets, the temperature of hot water inlet should be maximum
70°C.