Fraco FRSM-8000, Руководство пользователя, Страница: 6 / 69

WARNING!
SAFETY IS OUR PRIMARY CONCERN.
For this reason, never remove or alter any part in order to adapt the platform to fit a specific area of the
building.
USE ONLY GENUINE FRACO PARTS
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
FRACO (and/or its importer/representative) cannot be responsible for any property damage, severe
injury or death that may result from failure to comply with the following safety recommendations,
local rules and regulations.
Before operating this FRACO System, the following safety rules must be read and fully understood:
1- Mark out, with beacons or barricade tape and forbid the access around the base and the platform. This should be done
according to the local rules.
2- If using a gasoline engine, do not work in an explosive environment such as refineries, etc.
3- The operator should be familiar with the user's guide and understand all the functions of the platform.
4-
Never assume anything.
If you have any questions concerning the operation of the FRACO, STOP! Refer to the proper
user's guide. If you are still unsure, do not continue and call FRACO immediately.
5- In order to use, install or dismantle the system, a minimum of 2 people should be on the platform at all times,
in case of a breakdown or rescue.
6- The maximum working height is 11,58 m (38 ft) in the freestanding mode when in use and 4 m (12 ft) otherwise.
7- If you need to go higher than 11,58 m (38 ft), you must use anchors. In that case, refer to the user's guide.
8- Always use anchors when you are not using the freestanding base.
9- This platform should be maintained periodically. Refer to the user's guide.
10- In case of an electrical storm, LEAVE the platform.
11- For personal safety, when the wind exceeds 50 km/h (30 mph) do not use, install or dismantle the platform. Make sure
that the platform is lowered to the minimum.
12- Note the place where your fire extinguisher is located, and make sure that a certified person verifies it periodically.
13- It is the operator's responsibility to ensure that the load and the number of people allowed on the platform is
complied with. (Refer to the standard load distribution chart).
14- This platform should never be specifically used as an elevator.
Always wear your safety harness when installing and dismantling the mast sections, the wall ties and
when manipulating the planks when passing the anchors.
Safety harnesses that meet the local safety code must be available at all times for each person on the
platform. A safety line, in compliance with the codes and of sufficient length for the working height of the
platform must be available at all times on the platform for emergency use only.
Before raising or lowering the FRACO make sure:
1- That the base is properly secured in position and levelled (see the tolerances permitted in the user's guide).
2- That all guardrails are in place.
3- That a visual inspection above and below the platform is carried out, before each vertical movement, to ensure no
protrusions will impede or inhibit the proper movement of the FRACO.
4- To verify proper clearance for the walk boards (planks).
5- Not to exceed the freestanding height 11,58 m (38 ft) at the main
platform floor from the ground.
6- That the platform has not exceeded the height of the last anchor.
7- That the worker removing the boards to pass the anchors
is properly harnessed.
8- That everyone on board is alerted.
9- That the safety material is in the proper place and within reach of the operators.
Honda Gas Engine
Model: GX160-K1QHE
Vibration: 4.0 G Noise level: 74 dB
Operating speed: 3 600 RPM
©FRACO Products Ltd FRSM-8000 user's guide 09/2002 I-3