Frabill FRBSH195, Инструкция по эксплуатации

Страница: 15 / 40

Frabill Instruction • Manuel d’instructions 1-800-558-1005 • email: service@frabill.com • www.frabill.com 15
SET UP
1. Stand at the rear of the shelter and pull each U-frame [Z] toward you until the snap buttons snap into position
2. Move to front side and lift U-Frames [Z] toward you to enclose the base area. NOTE: if U-frames do not pivot
easily check to make sure tent is not caught on framework.
3. Continue until the first U-frame [Z] comes in contact with the ice
4. Depending on the weather conditions, the fit of the tent can be adjusted by moving the snap buttons to any
of the 3 holes in the U-frame [Z].
5. Insert the stretcher poles and adjust front stretcher pole to tighten tent.
TENT POSITIONS
Collapsed – Tent down resting on the base fro transport or storage
Closed – Tent rotated over the base onto the ice.
COLLAPSING FOR TRANSPORT
1. Remove all stretcher poles.
2. With the tent in the closed position, start at the back of the shelter, press the snap button levers in on each
side of the U-frame and lower the U-frame over the inner poles.
3. Repeat on the next 2 U-frames moving towards the door
4. Close the door with the zipper
5. Rotate the last U-frame to an upright position and then press the snap button levers in on each side of the
U-frame and lower the u-frame over the inner poles.
6. Fully rotate the frame to the collapsed position
7. Make sure all material is tucked into base to eliminate dragging the tent material.
8. Place stretcher poles, bucket and tackle inside base
(1.) Collapsed (2.) Closed
Safe Use and Operation