FPM 627 249, Установка / Обращение / Техническое обслуживание, Перечень запасных частей

Страница: 15 / 24

Page 15
LUBRICATION
Plastic bearings on the belts of double collecting elements must be periodically, at least once a year
lubricated (mandatory after the season of work).
Make sure that the lubricant does not come into
contact with V-belts as this will damage them.
At every 10 hours of operation, lubricate all the places where there are nipples with the grease ML-3
JUS B.H3.656 or VM-2 JUS B.H3.634.
LUBRICATION OF U-JOINT
Figure 3
1. - grease nipple at the front joint.
- every 8 hours.
2. - rotating part of the cover at the front part of PTO.
- every 40 hours.
3. - The inner part of the telescopic tube.
- every 20 hours.
4. - rotating part of the cover at the rear part of PTO.
- every 40 hours.
5. - grease nipple at the rear joint.
- every 8 hours.
6. - The lock pin at the front and rear part.
- every 40 hours.
7. - clean all parts of the PTO if not used for a long time
If you stick to this plan of lubrication, you will achieve longer life of PTO. By careful
maintenance you avoid failures which may occur due to heating of the bearings, damaging of the
bearings or increased axial force.
Lubricate PTO at the designated places, only with high quality
lubricants.
LUBRICATE ALL ROTATING, SLIDING AND U JOINTS AT THE FRAME
OF THE BELT RAKE.
WARNING: ALWAYS KEEP IN MIND TO USE THE PRESCRIBED QUALITY
LUBRICANTS TO AVOID DAMAGES OF THE MACHINE.
BY PROPER AND REGULAR LUBRICATION YOU ENSURE SMOOTH
AND SAFE OPERATION OF YOUR BELT HAY RAKE.
Control the lubrication of all spots with
installed nipples and other sliding surfaces. A
good level of lubrication is achieved every
eight hours of operation. Before lubricating,
wipe the surfaces of the earth and dust.
At
every fifty hours of lubricate turning and joint
parts. Also grease all parts that move one in
another (telescoping) when needed
.