FPM 627 249, Установка / Обращение / Техническое обслуживание, Перечень запасных частей

Страница: 14 / 24

Page 14
Setting-up the tension of endless V-belts is performed in the following manner:
First, setup the tension of the drive belt (Fig. 2, Pos. 1) through a screw with a counter-nut, on the
right side of the belt rake (Fig. 2, Pos. 2).
When deflection of the belt is 24 mm, use counter-nut to
secure the screw against unscrewing (Fig. 2, Pos. 3).
Setting-up of the belts (Fig. 2, Pos. 6) bearing the working elements at 40 mm of deflection is
performed by a screw in a similar manner as the previous setting-up, by means of screw on the left
side (Fig. 2, Pos. 2 and 3).
When it comes to the collecting of hay, the height of the collectors is set up by operating the lever on
a wheel support (Fig. 2, Pos. 4). This is set up so that both wheels are at the same height.
When
working on collection of hay one should set up the belt on the left side using the handle (Fig. 2, Pos.
5). This set-up is shown in Figure 5.
For raking, spreading and turning of the mowed grass, the left wheel must be adjusted with the lever
on the wheel support so that the collecting element on the right side of the belt rake viewed in the
driving direction is at a height of about 8 cm.
For these working operations it is necessary to remove
the belt, as schematically shown in Figure 5.
V-belts should be occasionally thoroughly cleaned and coated with glycerin to keep their elasticity
for a longer time.
WARNING: IT IS NECESSARY AND IMPORTANT TO CHECK THE BELTS TENSION
AND TO TIGHTEN THEM PROPERLY. IT IS PARTICULARLY IMPORTANT TO DO IT
AFTER THE FIRST 1/2 HOUR OF USE.
WHEN REPLACING THE WORN BELTS,
REPLACE THE WHOLE SET OF BELTS, REGARDLESS OF THE CONDITION OF ONE
BELT COMPARED TO OTHERS.
CAUTION
1. IT IS UP TO YOU TO PROTECT AND MIANTAIN THE BELT RAKE,
THEREFORE, IMMEDIATELY REPLACE ALL WORN OR DAMAGED PARTS
WITH THE GENUINE PARTS MANUFACTURED BY FPM AGROMEHANIKA AD
BOLJEVAC.
2. ALL WORK RELATED TO LUBRICATION, ADJUSTING AND REGULATION
MAY BE PERFORMED ONLY WHEN THE TRACTOR AND THE CARDAN
SHAFT ARE TURNED OFF.
3. WAIT TILL ALL MOVING ELEMENTS STOP AND THEN START SERVICING
THE BELT RAKE.
4. KEEP YOUR HANDS, FEET AND CLOTHING AWAY FROM MOVING PARTS OF
THE BELT RAKE
5. THINK OF THE CONSEQUENCES OF IRRESPONSIBLE WORK SINCE THEY
ARE IRRECOVERABLE.
6. BEFORE YOU TURN ON THE TRACTOR AND START WORKING, MAKE SURE
THAT OTHER PERSONS AND ANIMALS ARE NOT IN THE AREA OF WORK OF
THE BELT HAY RAKE.
ATTENTION: STOP AND THINK! ROTATING ELEMENTS CAN CAUSE
SERIOUS BODY INJURIES.