12
3.3 INSTALLATION OF COLLECTING WHEELS BEARINGS TO THE MAIN FRAME
For installation of the collecting wheels bearings (Figure 3 pos. 1) to the main frame, first remove the flat washer and the clip
from the sleeve of the collecting wheels bearings (pos. 3 and 4), then pull the sleeve in the opening on the main frame and
secure the connection by placing the flat washer and clip on the sleeve. Bend the ends of the clip.
ATTENTION!
Secure the frame against tipping over
and swing during installation.
3.4 INSTALLATION OF THE COLLECTING WHEELS
Install the collecting wheels (figure 4, pos. 1) to the collecting
wheel bearings (figure 4, pos. 2).
To connect, use the screws
that are located on the bearing (the hub).
CAUTION!
Be sure to properly install the collecting
wheels. The wheel is properly installed if the
pressure plates (see figure 5) are facing
forwards, i.e. towards the tractor.
REMARK:
Collecting wheels for the left and
right sides are different and therefore are
clearly
marked.
Make sure to install them on
the right side.
Pressure plates
LEFT WHEEL
RIGHT WHEEL
PRESSURE
PLATES
LEFT SIDE
RIGHT SIDE
LEFT SIDE
RIGHT SIDE
