FP InovoLabs FP S-Compact BB, Установка и безопасность

Страница: 8 / 60

FP S-Compact BB / LAN
8
Avoiding danger from electrical voltage
Carry out the following safety measures to avoid hazards due to electrical voltage.
Before removing the protective cover for the power supply inside the FP S-Compact:

Disconnect the device from the power supply.

Secure it against restarting.

Keep unauthorised persons away from the device.
Before starting work on the FP S-Compact:

Make sure that the device is voltage-free.

Observe the safety and accident prevention regulations applicable for the specific
application and location.
Before putting the FP S-Compact back into operation:

Make sure that the protective cover for the power supply is properly attached.

Check that all unused cable glands have been sealed with a suitable sealing plug.
This is the only way to maintain the IP65 protection rating.

Fasten the housing cover to the housing with the four fastening screws. Tighten the
screws with a torque of 0.7 Nm to 1 Nm (0.52 ft lb to 0.73 ft lb).

Make sure that the device is closed correctly.
2.5 Accessories and consumables

Use the supplied cables or cables that have been approved by FP InovoLabs.
Make sure that the cables are not damaged.

We recommend to use only approved FP equipment and FP original parts.
The manufacturer FP has established reliability, safety and applicability.
The manufacturer cannot assess the reliability, safety and applicability for products
not approved by FP, and therefore not vouch for such products.

Observe the manufacturer’s specifications for the hardware modules used.

If you pass the FP S-Compact on to someone else, make sure that this guide is also
passed on along with the device.