30
NT650Elite Multi-Application Service Tool Manual_English_V1.01
brake pads, and setting brakes after disc or pad replacement, on multiple brands of vehicles where
electronic brake systems are fitted.
Some tests display a command to the operator. For example, if “Pressing Brake Pedal” displays, the
operator has to press and hold the brake pedal and then continue. Actual tests vary by vehicle
manufacturer, year, make.
Typical special test options include:
●
Deactivate/Activate SBC/EPB systems
- allows to deactivate brakes for further service or
maintenance work on brake systems or activate brakes when service or maintenance work on
brake systems are completed.
●
Adaptation on Audi A8
- allows to set new pad thickness of rear brakes calipers after changing
brake discs & pads on Audi A8 models.
●
Replace hydraulic brake systems fluid/bleed brake system on Mercedes SBC vehicles
-
allows to change brake fluid/bleed brake system.
●
Perform service reset and service position on BMW EPB vehicles
- allows to do the CBS
reset and CBS correction for front brake and rear brake.
●
Perform activation/service work on Volvo PBM vehicles
- allows to perform installation check,
applying parking brake, releasing parking brake, activating service mode and exiting service
mode.
●
Reset memory on Toyota EPB vehicles
- allows to clear the learned memory of the EPB ECU.
●
Perform brake cable replacement and electric parking brake replacement
- allows to fit in or
remove the brake cable safely, adjust brake cable’s tension and calibrate the electric parking
brake replacement.
●
Save and write clutch pedal programming on Renault EPB vehicles
- allows to save clutch
pedal programming on Renault vehicles fitted with manual gearbox. After this command is
activated, the tool allows to "flash" the electric parking brake unit with the saved clutch data.
●
Perform control function and reset function on Opel EPB vehicles
- allows to apply/release
park brake cable service, provide park brake cable service replacement procedures and calibrate
the parking brake systems after brake service.
●
Sensor calibration on Honda EPB vehicles
- allows to program the current output value of each
sensor into the electric parking brake unit.
●
Provides parking brake unjam procedure and perform longitudinal accelerometer
calibration on Land
Rover
EPB vehicles
- allows to drive the electronic park brake so it is
unjamed in the releasing direction and then drive it into mounting position or the latching position;
also allows to perform longitudinal accelerometer calibration.
●
EPB systems must be deactivated before carrying out any maintenance/service work on the
brakes such as changing of pads, discs and calipers.
●
Use proper tools to avoid the risk of body injuries of mechanics and technicians and damage to
the brake system.
●
Make sure the vehicle is properly blocked after deactivation of the systems.
6.3 Battery Replacement (BRT)
BRT
menu lets you to n to validate new battery, clear faults from the dashboard and display current
battery details of the vehicle such as Audi, BMW, Citroen, Peugeot, Seat, Skoda, Volvo, VW and Ford.
1. Replace the old battery with the new one. Ensure the key is not in the ignition.
2. Connect the scanner to the vehicle’s 16 pin Data Link Connector (DLC) with the diagnostic cable.
3. Boost the device and select BRT; it will display all the vehicle makes available. Choose your
vehicle make and follow the scanner instruction to start.
●
Sensor calibration on Honda EPB vehicles
- allows to program the current output value of
each sensor into the electric parking brake unit.
●
Perform BRT on Citroen/Peugeot cars
– make several selections to confirm your car model,
and then complete the battery replacement following on-screen instructions.
