57
Premier Diagnostic Platform i70Pro User's Manual V1.01
6.7 Continuous Variable Transmission (CVT)
This function is used to reset the compensation code and initialize the ECT
after a solenoid valve or valve body assembly has been replaced.
6.8 Gear Learning
The crankshaft position sensor learns crankshaft tooth machining tolerance
and saves to the computer to more accurately diagnose engine misfires. If
tooth learning is not performed for a car equipped with Delphi engine, the MIL
turns on after the engine is started. The diagnostic device detects the DTC P
1336 'tooth not learned'. In this case, you must the diagnostic device to
perform tooth learning for the car. After tooth learning is successful, the MIL
turns off.
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is
replaced, or the DTC 'tooth not learned' is present, tooth learning must be
performed.
6.9 Tire Pressure Monitoring System Programming
TPMS Service
menu allows you to check the tire sensor IDs from the vehicle
ECU and to perform TPMS programming and reset after tires and/or TPM
sensors are replaced and/or tires are rotated.
6.10 Odometer
This function allows you to revise the date of odometer and write the original
date into new odometer.
6.11 Injector Coding
Write injector actual code or rewrite code in the ECU to the injector code of
the corresponding cylinder so as to more accurately control or correct
cylinder injection quantity. After the ECU or injector is replaced, injector code
of each cylinder must be confirmed or re-coded so that the cylinder can better
identify injectors to accurately control fuel injection.
6.12 ABS Bleeding
Anytime the brake system is opened to replace components such as calipers,
wheel cylinders, the master cylinder, or brake lines or hoses, air gets inside.
The air has to be removed by bleeding the brakes if you want a firm brake
