- 29 -
Default Parameters of the video&data link module
User name: admin
Password: ADMIN
LAN port IP: 192.168.168.11 (receiver); 192.168.168.12 (remote control)
Serial port baud rate: 115200, 8N1
8.2. V20 Video&Data link Serial Port Operation
Default baud rate of the serial port is 115200
, pls refer to the following steps to connect
the flight control, ground station software.
1. Connect the flight controller to the airborne unit. Pls pay attention to the line sequence
and the baud rate of the flight control port must be consistent with that of the serial port.
2. Connect the ground station software to the ground unit. Note that the connection line
sequence and the baud rate of the connection port of the ground station software must be
consistent with the baud rate of the serial port.
3. Change serial port baud rate. (Please modify baud rates of both airborne unit and
ground unit simultaneously)
①
Power on the module and CPU light will be ON.
②
Connect the computer and the LAN port of V20 receiver with LAN-to-4pin line.
(The LAN port of the internal module of the remote control has been connected to the
LAN port)
③
The computer must set its network settings (TCP/IPV4 properties) to
automatically obtain the IP address (as shown below).