VDC-30 Long Range Video/Data/RC Wireless Transmission System
User Manual
©
2020 FOXTECH All Rights Reserved
11
VDC-30 CODEC Module JM30
VDC-30 with Mission Planner
If your gimbal has a HDMI/SDI/AV interface, you can add CODEC module JM30 to work with VDC-30. JM30
contains encoding module JM30E and decoding module JM30D. You only need one single cable in the
accessory box to connect VDC-30 and JM30. It is shown in the picture below.
For more information, please refer to the JM30 user's manual.
Follow the steps to use VDC-30 with Mission Planner×
1.Connect the UART1 of VDC-30 air unit to flight controller, such
as Pixhawk. Connect the gimbal to one ethernet of VDC-30.
2.Making sure all the air and ground cable connection is finished.
Power on the system.
3.Install Mission Planner to your computer.
4.Set the IP address of the computer.
Open “Network and Internet”setting.
Select “Internet Protocol version 4 (TCP / IPv4) properties”.
Change IP address to “192.168.1.xxx”×xxx is in 0×255 , you
cann’t use IP 192.168.1.200 and 192.168.1.236, because these
IP were set in VDC-30×.
Attention
×
The IP “192.168.1.XXX”is just an example. You
need to set up your PC the same IP section as your gimbal.
5.Get data
There are three methods to get data from VDC-30 ground unit, using Mission Planner×
- UDP port via Ethernet;
- TCP port via Ethernet×
- UART (COM)
Get data from UDP port.
