Foxfury Lighting Solutions 200-800, Руководство по эксплуатации продукта, Страница: 13 / 20

13
Make sure the Nomad
®
is OFF and UNPLUGGED before starting.
1. Open the Folding Tripo-Scope
®
Legs so they are locked and deployed.
Then, locate a Battery Cover.
2. Use a Phillips Head (+) #1 Screwdriver to remove the four (4) screws that
hold the Battery Cover. Once the screws are removed, pull the Battery
Cover off and set it aside.
Once the Battery Cover is removed, the Battery Tube is accessible.
3. At the TOP of the Battery Tube, there will be a red (positive) Battery
Tube Cap. Place an index finger on it and pull the tube out by the red Cap
(this should then help the bottom portion (black Cap) of the Battery Tube
to easily slide out of the Battery Compartment). This action is similar to
removing a AA battery from any generic battery holder.
To easily remove the Battery Tube from the Nomad
®
Body, it is best to
pull straight out from the "crown" of the Red Cap.
NOTE: The wiring for the positive (+) and negative (–) Caps will remain
attached to the Nomad
®
Body while the Battery Tube is pulled out of
the Battery Compartment.
4. Remove the Battery Tube Caps (red and black) from each end of the
Battery Tube. This can be done by simply popping the Battery Tube Cap
off with one thumb.
DO NOT pull the Battery Tube Caps by the wires.
REPEAT STEPS 1– 4 FOR THE 5 REMAINING BATTERIES.
2
3
4
1
IMPORTANT!
Please follow applicable laws and regulations for transport and disposal
of batteries. For details on recycling please contact a government
recycling agency, a waste-disposal service, or visit reputable online
recycling sources such as www.batteryrecycling.com.
!