Foxfury Lighting Solutions 200-800, Руководство по эксплуатации продукта, Страница: 11 / 20

11
1. Set the Nomad
®
down vertically, on a flat surface, as shown. Open the
Protective Light Cap and twist the Locking Sleeve to the right ( ) and
slide upwards ( ). While still holding the Locking Sleeve up, twist it back to
the left ( )
. The Folding Tripo-Scope
®
Legs are now accessible to deploy
( ).
2. Unfold each Tripo-Scope
®
Leg and make sure they are locked in place by
the Leg Locks (see the "Nomad
®
Reference Guide" on pg. 3 for location).
3. Pull the Light Head up from inside the Locking Sleeve. If using for
directional lighting, tilt and adjust the Light Head accordingly. Then, based
on preference or need, adjust the Diffuser Lens to either Spot or Area
lighting (see "Diffuser Lens" on pg. 8 for more information).
4. Adjust the angle and swivel position of the Light Head by loosening the Tilt
Adjustment Knob to the desired orientation and then re-tighten.
Light Head placement and adjustment can be made easier by
tightening the Hinge Screw (located near the Tilt Adjustment Knob).
5. Elevate the Light Head to desired height by raising the Tripo-Scope
®
Poles.
Tighten the Tripo-Scope
®
Tightening Rings (clockwise) to hold the poles at
desired height.
IMPORTANT: To reposition, loosen the Tightening Rings, bring the
Tripo-Scope
®
Poles down again and turn the Light Head OR physically
pick up and move the position of the whole Nomad
®
. DO NOT TRY TO
TURN THE TRIPO-SCOPE
®
POLES AGAINST EACH OTHER. This
can cause permanent damage.
6. On uneven ground, adjust each Tripo-Scope
®
Leg individually, as necessary.
Lift the leg off the ground, and then, using both thumbs, press and hold
both of the Leg Extension Release Tabs until the Leveling Leg Extensions
(located at the end of each of the Tripo-Scope
®
Legs) are released.
Retract the Leveling Leg Extensions in the same manner.
Fine adjustment can be made by turning the Leveling Leg Extension
by hand. Use the Level Bubble for reference.
In case of heavy wind or extreme weather conditions, attach a sand
bag, or equivalent weight, to the concealed Anchor Strap (see the
"Anchor Strap" on pg. 9 for location).
THE NOMAD
®
IS NOW READY FOR USE!
B
A
C
D
2
3
4
5
6
1