Foxfury Lighting Solutions 200-4N32, Руководство по эксплуатации продукта, Страница: 14 / 18

14
MAINTENENCE (CONT'D)
GENERAL TIPS
The Nomad
®
reaches a full charge in approximately 4 hours. (Charge time
may depend on ambient conditions and battery health).
Maintain the light fully charged at all times, so that it is ready for use in
the event of an emergency.
If used outdoors in cold weather for an extended period of time allow
the Nomad
®
to warm up to above 10°C/50°F before charging.
Lithium-Ion batteries have a 500 full charge cycle life (CC followed by a
CV cycle)*. When the light gets near this number of cycles, there will be a
decrease in usage time. *CC=Constant Current charge (fast rate)
The Lithium-Ion batteries have a top-off or micro-charge life of around
1,200 cycles or more (CV only)*. If the Nomad
®
is un-used for 60 to 90
days, plug in the AC-DC Adaptor for 1 to 2 hours to bring the batteries
back up to peak charge. *CV=Constant Voltage charge (slow rate)
As needed, wash the Nomad
®
using a soft washcloth, clean
water and a mild soap. When done, pat dry with a soft cloth.
STORING THE NOMAD
®
Make sure the light is powered OFF by pressing the Power/Mode Switch
until the light is no longer ON.
Press the Remote Switch to turn OFF the remote. If it is not turned OFF,
the battery will drain over time.
If the AC-DC Adaptor or 12VDC Vehicle Adaptor is being used,
disconnect it from the Nomad
®
and store.
WARNINGS WHEN STORING
The Nomad
®
depends on “ambient air” for cooling of its Light Head. After
being ON for a while, the Nomad
®
Heatsink Fins (which help disperse
heat), behind the Light Head will become warm to the touch (possibly
hot). This depends on the run time, setting, and/or air temperature. The
warmer the ambient air temperature is, the faster the Light Head’s
temperature will increase.
When it is time to put the Nomad
®
away, either wait for the unit to cool off
(usually 10 - 20 min) or protect hands (with work gloves or a cloth) while
adjusting the Light Head.