Foxfury Lighting Solutions 200-4N32, Руководство по эксплуатации продукта, Страница: 13 / 18

13
REPLACING THE BATTERY PACK | 4 MINS
(APPROX)
1. Attach the new Battery Pack to the light by re-clipping it the Connector.
Then, place the new Battery Pack back inside the Nomad
®
.
2. Place the black strap over the Battery Pack. Then, re-insert and tighten
the two (2) screws.
3. Place the rear panel back onto the Nomad
®
. Align as needed (it will only
properly fit in one direction). Re-insert and tighten the eight (8) screws
using a Phillips screwdriver.
NOTE: Remember to test the light’s performance by activating the Power/
Mode Switch.
REMOVING THE SLIDING DIFFUSER LENS | 3 MINS
(APPROX)
1. Slide the Sliding Diffuser Lens back into the 'Area' setting. Locate and
remove the four (4) screws located on each side of it.
2. Then, tilt the Sliding Diffuser Lens forward.
3. Pull the Sliding Diffuser Lens out and free from the Light Head.
FOR RE-INSTALLATION: Repeat the steps above in reverse order.
2
1
1
2
3
3