16
DUST EXTRACTION
1.
Insert one end of the extraction hose onto the nozzle of saw blade protector 7 and the other end in the
extraction nozzle 15.
2.
Attach a suitable vacuum cleaner to the dust extraction nozzle 15.
MAINTENANCE
Before any intervention on the machine (installation, adjustment, blade replacement…) always make sure that the
machine is unplugged.
Cleaning
--When the table saw has been used for some time, dust or other substances can prevent the proper operation of
the machine (essentially the rotary parts). You can clean the equipment using a blow gun. Check frequently your
machine. Be aware of any problems that may occur to the power cord, the plug, or the switch.
--To avoid overheating the motor, check regularly that the dust does not obstruct the ventilation opening of the
motor. The presence of the sparks into the ventilation slots is normal and will not damage the tool.
-- Cleaning the plastic parts should be done with disconnected machine with a soft wet cloth and mild soap. Never
immerse the table saw and do not use detergent, alcohol, gasoline, etc. For a thorough cleaning, contact the After-
Sales Service. Cleaning aluminum parts must be done using a non-corrosive product to such material.
--Remove regularly chips and dust with a vacuum cleaner or a brush.
--Check frequency all bolts and screws are properly tightened.
The table saw has been lubricated at the factory and therefore needs no special libration.
Replacement of parts and maintenance
Check periodically the power cable, if the power cable is damaged, it must imperatively be replaced by the
manufacturer, its service agent or a similarly qualified person in order to avoid danger.
Warning! As with all power tools, there are potential hazards involved with the use of this Table saw. It is,
therefore, vital to ensure you read, understand and apply all the safety instructions in Section 1.Familiarize yourself
again with the specific safety rules for each step of the following operation. Failure to do so may cause serious
damage and/or personal injury and may invalidate your warranty. Disconnect the table saw from the mains power
before making adjustments or changing blades. Ensure that all clamps, screws and nuts are secure and that the
blade is in good condition and correctly mounted. ALWAYS have the blade guard down before turning on the table
saw. Wear approved safety eye protection.
