13
INSTALLATION AND ASSEMBLY
* Installation of side extension of the table
The support consists of four table legs with cross braces which must be fitted .
Tools required :
-2 ring spanners ,size 10 (one is needed for counter tightening ).
-1 Allen key 4 mm
1.
Assemble the four table legs A with the four cross braces B .Each cross brace must be fastened to each table
leg using bolts C (including washers)and counter nuts D.
2.
Fasten the side extensions from below using two hexagonal bolts E for each pre-drilled hole provide on the
outside edges of the table saw .
3.
From below ,fix two supports F ,using bolts C (including washers ) and counter nuts to fix the side extensions
.Screw the extension supports F to the frame housing (threaded hole )using two bolts (including washers )
4.
Fix the support to the table saw .For this ,match up the holes on the upper end of the table leg A to the
threaded holes of the frame housing .
5. If necessary ,the support can be fixed to the floor .The material required for this is not included
In the delivery .
Note: Place the machine only on a flat ,non -slip surface. The machine must not rock .
FITTING ACCESSORIES
Parallel Guide
The parallel guide 7 to be pushed onto the fixing block at corresponding guide height .
1.
Loosen both wing nuts on the fixing block 6 until the slide plate J is free .
