40
EN
CUTTING A WOOD PIECE
WARNING!
Before starting to cut, make sure the mitre saw has been correctly assembled and set. Make
sure you have red and understood all the safety instruction included in this manual
To cut a piece:
1. Lift the head to its higher position.
2. Select your desired angle and block the knob.
3. Select your desired bevel inclination angle and block the knob.
4. Make sure that the piece dimensions are suitable with the mitre saw.
5. Hold strongly the piece on the base, using the vertical and horizontal clamps.
6. Hold strongly the wide pieces to prevent them from tilting; in case of need use the lateral extensions.
7. Check that your hands are away from the disk path.
8. Pull the arm towards you, along the sliding guides, holding the operating handle.
9. press the trigger to start the machine and wait until the disk has reached its maximum speed.
10. Slowly lower the disk through the piece and let the disk slide in the opposite direction to cut all along the
piece. Do not put high pressure on the disk: your cut will be more efficient and precise if the disk turns at
the correct speed.
11. Release the trigger, wait for the disk’s complete stop and lift the arm to the upper position after the cut is
done.
WARNING!
Do not cut metal with your mitre saw. This machine is not granted for metal cutting. The
manufacturer is not responsible for problems caused by the misuse of the machine.
CORRECT USE OF THE SLIDING DEVICE
Note
: it can be dangerous to cut pulling the head towards you: the disk could “climb” in the material and raise
towards yourself. Always push the disk in the opposite direction, away from you, when you slide-cut. The
following points describe how to slide-cut correctly:
1. Place the piece on the base of the mitre saw, against the cut-end guide. Hold the operating handle,
without pressing the trigger.
2. Pull the arm towards you, keeping the arm in the upper position. Then press the trigger to start the
machine.
3. Push the protection locking button and push the operating handle.
4. Push the arm towards the cut-end guide, to complete the cut.
5. Release the trigger and keep the arm down until the disk comes to a complete stop.
6. Once the disk stops, lift the head in its higher position.
CUTTING WITHOUT SLIDING DEVICE
When cutting a narrow piece, the sliding device is not needed.
In this case, block the sliding device in the back position by tightening the sliding control knobs and cut
traditionally, pulling down the head onto the piece.
When the cut is finished, release the trigger keeping the head down until the disk comes to a complete stop;
then lift the head to the upper position.
Содержание F36-257DB
