38
EN
SETTING THE CUTTING DEPTH
The vertical depth of the cut can be adjusted, allowing the mitre saw to cut a groove
When setting the cutting depth make sure that the disk may not touch the base, in the lower position; the disk
could damage the base.
To set the depth:
1. Lift the head in the higher position.
2. Loosen the bolt
(C) Fig.12
.
3. adjust the knob
(B)
to the desired cutting depth.
4. tighten the bolt
(C).
Note
: In case the cutting depth
(A)
is set too short, the disk wont cut through the work-piece. Always make a
test-cut after setting the cut depth
SLIDING CUT
1. Loosen the knob
(A) Fig.13
to release the sliding device.
2. Pull or push the operating handle to slide the head along the guides.
3. Tighten the knob
(A)
to block the sliding device.
Note
: Warning ! before transporting the mitre saw, make sure that the sliding device is blocked
WORK-PIECE SUPPORTS
Use the lateral extensions available, to support long pieces during the cut. Position the extensions as described
above, see CUT-END GUIDE EXTENSIONS.
OPERATING
HAZARDOUS AREAS OF THE TABLE
The working area on the table is designated as “hazardous area”.
Never have your hands inside this area, during the cut
TURNING ON / OFF THE MITRE SAW
To turn on and off the machine :
1.
Connect the feeder cable to the electric socket.
2.
Push the starting switch B and the run button C to start the mitre saw.
3.
Release the ON button to stop the mitre saw.
WARNING!
Do not cut short work-pieces: a too short piece won’t allow you to keep your hands at a safe
distance from the disk. Never cross the hands nor position them in the cutting area.
Содержание F36-257DB
