Fox Evo Bivvy XS, Руководство пользователя

Страница: 4 / 17

GB
6
GB
7
EVO BIVVY XS
EVO BIVVY XS
The remaining socket is for
the fitting of a Winter Skin
which can be purchased
separately. This image shows
the right hand boss from the
front of the Evo Bivvy XS.
8.
9.
To dismantle the Evo Bivvy XS, unhook the tension elastics if they
have been used, and remove all pegs. Standing at the front of the
Evo Bivvy XS place a hand on top of the boss and apply gentle
downward pressure, tilting the boss towards you. At the same
time lift the front pole slightly upwards and slide out. Repeat for
the other front pole.
10.
Disconnect the rear poles.
11.
Remove the short centre pole.
This should be done by lightly
pressing down on boss and
centre pole to decrease the
tension. As the centre pole
straightens it is simply
disconnected from the two
bosses. Store the pole inside one
of the front mesh tunnels.
12.
Gather all of the poles
together and roll the Evo
Bivvy XS up, storing it in
the supplied sleeve.
13.
NOTE: Like all materials, the cover to the Evo Bivvy XS may be affected by hot or wet weather.
This may cause the cover to go slack in wet conditions or tighten during warm weather.
To allow you additional flexibility, you will see that above each moulded foot there is an elastic
loop fitted to the cover. These may be hooked over the claws on each moulded pivot which will take up any slack in
the cover.
The Evo Bivvy XS is now fully
erected - peg down the two rear
pegging points. A unique feature
of the Evo is that it can be set at
a range of different heights and
widths. To alter the size and
shape simply move the two side
poles outwards to lower and
increase coverage in bad weather,
or move them inwards to
increase the height and narrow
the shelter to fit tight swims. The front panel features 3 steel
pegging points for tensioning the Bivvy at the required height.