FOVNO ES-L04, Инструкция по эксплуатации, Страница: 8 / 15

Installation Notes
1.Installation method of the crossbar and suction foot group: Install the M6 countersunk head screw and square nut on the suction text according
to the method in Figure ①, please do not tighten it.(The installation method of the screws and nuts of the front and rear suction foot groups is
the same, pay attention to the direction of the pneumatic hose interface on the suction foot group towards the inner side of the crossbar)
2. Remove the covers and decorative strips on both sides of the crossbar, as shown in Figure ②. Then slowly slide the suction foot group into the
chute under the crossbar according to the method shown in Figure ③.
Note: when installing the wider side of the crossbar faces the front of the vehicle
.
Dimension drawing of cross bar chute
20.5mm
10.5mm
8.25mm
11.25mm
25mm
Front suction foot group
①
③
Length 1200mm
②
18