Date: 2017-06-28
PPA DSP amplifier user manual
26
First select a PPA device (in this example we are using a PPA-2200-3) and select Single Ended or Bridge Tied Load
mode. Our desired setup needs SE mode. On changing the model or bridging mode with at least one preset
present in your list, you are asked to convert these presets to the new configuration. Double-clicking a preset
name allows to change its name.
Select the input source. Choose between
analog 1, analog 2, analog 1+2 (both signals summed up. There is no gain compensation of -6 dB!)
Applies for 2Ch PPA configuration
analog DRC: If your device is configured as DRC choose this option for analog in.
AES for digital AES input. Choose between Channel 1, 2 or the sum of both.
Dante for digital input using the optional Dante interface.
Device Settings: This means that the input is used, which has been chosen for the device, either at the
display or in the PPA Manager.
In our example, we are going to use analog inputs 1, 2 and the sum as shown in the above figure.
Figure 13 PPA Developer
Signal source
selection
SE / BTL
mode
Device selection
Preset list
new Preset
curves
section