Four winns 318 VISTA, Руководство пользователя

Страница: 91 / 236

Owner’s Manual Page Water and Waste Systems - Section J
Periodically.check.the.sump.pump.screen.for.clogs..
to.prevent.drainage.problems.from.occurring.in.the.
shower.drain..Refer.to.the.manufacturer’s.literature.
included.in.the.owner’s.packet.
J - 3 GREY WATER SYSTEM
The.grey.water.system.is.optional.on.Vista®.models...
The.water.from.the.galley.sink,.head.sink.and.shower.
will.drain.into.a.sump.and.is.pumped.into.a.grey.water.
holding.tank.respectively...The.waste.level.indicator.is.
located in the head compartment. A pumpout fitting
labeled.WASTE.but.designated.for.grey.water.is.
provided.on.the.deck..Refer.to.the.drawings.at.the.
end.of.this.section..
NOTICE
Certain geographical areas have restrictions
on grey water being pumped or drained
overboard. Be sure to check all local, state
and federal laws in the boating area.
J - 4 SHORE WATER CONNECTION
Shore.water.connection.is.standard.on.the.318.Vista
®
.
models..This.feature.allows.the.direct.connection.of..
a.city.or.shoreside.water.supply.to.the.boat’s.water.
system.to.provide.a.constant.supply.of.fresh.water.
without the need to constantly refill the water supply
tank..This.minimizes.pressure.pump.operation.thus.
extending.the.life.span.of.the.pump.
Dockside.shore.water.pressure.can.vary.dramatically...
Excess.pressure.could.damage.the.boat’s.water.
system.so.the.shore.connection.also.regulates.the.
water.pressure.to.a.maximum.of.35.psi..
The shore water inlet/regulator fitting is located
outboard,.on.the.starboard.side.of.the.transom.above.
the.swim.platform,.inside.the.transom.washdown.
storage.area..See.Figures.J-3.and.the.drawings.at.the.
end.of.this.section.
To.use.shore.water,.connect.a.hose.from.the.shore.
water faucet to the shore water fitting on the boat and
turn.on.the.shore.water..The.water.system.of.the.boat.
will.then.be.pressurized.by.city.water.if.the.system.
was.previously.primed.
On.the.318.Vista
®
.models.the.water.heater.incorpo-
rates.a.heat.exchanger..The.heat.exchanger.allows.
the.engine.coolant.to.heat.a.portion.of.the.fresh.water.
supply.while.the.engines.are.operating..This.option.
will.provide.hot.water.at.times.when.120.volt.power.is.
not.available..Additional.information.on.heat.exchang-
ers.is.covered.in.the.engine.and.hot.water.heater.
manufacturers’.manuals..Please.refer.to.Section.H..
on.Electrical.Systems.for.additional.information..
D. Using The Shower
Turn.on.the.faucets.to.desired.temperature,.remove.
the.shower.spout.from.its.holder,.move.the.diverter.
lever.on.the.shower.head,.and.the.shower.is..
operational.
When.using.the.shower,.draw.the.shower.curtain.
before using the shower. Damage to the finish can
result if surrounding walls and flooring are allowed to
become.excessively.wet..Thoroughly.dry.these.areas.
after.showering.
The water temperature can vary during shower
use as the pressure pump cycles on and off.
For greatest consistency, turn the cold water
on full, then mix in hot water until the desired
temperature is obtained.
A.shower.sump.pump.is.incorporated.into.the.drain.
system.of.the.shower..The.shower.drains.into.the.
sump.pump.located.forward.of.the.aft.cabin..The.
water.will.then.be.pumped.overboard..If.a.grey.water.
system.is.installed,.the.water.will.be.pumped.into.the.
grey.water.holding.tank.
The.sump.pump.includes.an.automatic.bilge.switch.
and.is.protected.by.a.circuit.breaker.at.the.AC/DC.
cabin.panel..The.sump.pump.will.automatically.start.
as.soon.as.the.water.in.the.sump.reaches.a.level.that.
will cause the float on the switch to rise.
After showering, let the water flow for a period of time
to flush the pump of soap residue. Check the sump .
for.excess.residue..When.rinsed.out,.the.pump.will.
automatically.shut.off.
If water flow from the shower head appears to be
restricted,.it.may.be.due.to.sediment.accumulating.at.
the.shower.head..If.necessary,.remove.the.head.and.
clean the discharge holes with a fine wire.