FOUR WINDS INTERNATIONAL Class A, Руководство пользователя

Страница: 82 / 108

FOUR WINDS INTERNATIONAL
WATER SYSTEMS
81
TECMA Toilet
The Tecma toilet is connected to the pressurized fresh water system, and has two flush modes available.
Unnecessary frequent flushing of the stool will quickly deplete the fresh water supply and will also fill the
holding tank. If the black water tank becomes full, you will no longer be able to flush the stool until the tank
can be drained.
•
Water Saver Flush: Press and release the button to flush liquids.
•
Normal Flush: Press and release to flush solids and toilet paper.
•
Empty Bowl: Press both buttons simultaneously and release to empty bowl and
leave it dry for travel. Press either button once to return to normal use.
Note : The TECMA toilet operating instructions are located on a label on the underside of
the seat cover. Refer to this label when programming the water level.
WATER SYSTEM WINTERIZATION
If you intend to store your motor home through periods of subfreezing weather in an unheated environment,
it will be necessary to winterize the water system. Damage to water system components will result if proper
winterization steps are not taken:
Note : Four Winds recommends this be done by a qualified technician or dealer.
Class A Water System Winterization
1. Level the unit for good system drainage.
2. Drain the waste water tanks (black then grey following drainage guidelines) and fresh water
tank.
3. Turn the water pump switch off.
4. Open all faucets, and water heater drain.
5. Open low point drains on the water lines, including the outside shower.
6. When all lines are drained, close water tank valve, all faucets, water heater drain, and low
point drains on water lines.
7. Turn water heater bypass valve on to prevent tank from filling with antifreeze.
8. Remove water filter (if installed) and replace with bypass cap to protect filter.
9. If unit is equipped with an ice maker, turn off the water valve.
10. Position antifreeze so siphon hose can be connected to the winterizing connection.
11. Turn valve to position which will allow the water pump to pump from antifreeze container.
12. Turn on the water pump and let each faucet run until antifreeze flows freely from both hot and
cold lines. Also run the shower and toilet until antifreeze is visible.
13. If unit is equipped with a washer/dryer turn on and let run until antifreeze is visible and
continue to run for 15-20 seconds. Turn cycle selector to rinse cycle to ensure the antifreeze
gets into the pump to protect it.
14. Turn off water pump.
15. Pour one cup of antifreeze in every drain to protect the P-traps.