PATIO COVER INSTRUCTION SHEETS
PATIO COVER INSTRUCTION SHEETS
G
H
I
J
Take Second piece of Extruded Gutter(#D).
Measure inside
the LEFT End
of Extruded
Gutter(#D)
11-1/2" and mark it.
Hook Tape on Left End of extr Gutter(#D)
and
measure to the
RIGHT
and
mark at 2” & 10" on gutter face
… then
Measure up 1" from Gutter Bottom and
Down 1" from the TOP. Make the 4 Marks for Screw
Locations
on the Face
of Extruded Gutter.
Use sealant in the bottom corners of the Gutter, zig zag across the bottom, the gutter front and
back
as in STEP 6B. Squeeze a caulking bead 3/4" from front edge
of roof panel on
TOP of
Roof Panels to the END
Hold the Second Extruded Gutter(#D)
at the
end of the Gutter Splice(#C). Slowly push the
gutter onto the Roof Panels
and
slide to the LEFT over the Gutter. Splice
until the two gutters
butt together
Align the two Gutters for a good fit,
making
sure they are straight
, pull them in or out for that
good tight fit…at the Four Marked locations
fasten through the FACE of second Gutter into the
Gutter Splice. Caulk and Seal inside the splice ... screw threads and RIGHT edge of Splice
as
in STEP 6D
When splice joint is a good tight fit,
adjust gutter to be straight on the roof panels.
Staying
4inches away from the Roof Panel Seam
near the Splice,
Fasten through the Gutter Leg
downward into the Roof Panel using one(1) #10 tek screw.
Go to
Far RIGHT END of Roof
panels staying
4inches away from the RIGHT Edge
of Roof
Panel,
Fasten through the Gutter Leg downward
into the Roof Panel using one(1) #10 tek screw.
LifeRoom ONE Installation Guide
