PATIO COVER INSTRUCTION SHEETS
PATIO COVER INSTRUCTION SHEETS
D
E
F
G
H
I
I
Cut open a tube of sealant and load into caulking gun. Set ladder at house side, left end of Roof Header.
Looking from backyard at the house,
have the FEMALE EDGE of ROOF Panel to the LEFT side
.
Look
at both sides of the panel for any dents
…if there is a dent or ding you can
flip the panel so the dent
will be on the TOP
of the S.I.P. Patio Cover.
On the
HOUSE end of the ROOF PANEL, on the TOP side
, squeeze out a 1/4" bead of sealant on the
Aluminum skin
ACROSS the 23" direction
staying
1 inch away from the REAR edge of the panel
Use the cardboard end caps from roof panels or a towel and set on top of beam to protect roof
panels from scratching.
Slide the gutter end of panel over the 3x3 Edge Beam…
then slide
Roof Header end of
panel into the
Roof Header until it hits.
Set the Female edge of roof panel even with the LEFT edge of Roof Header.
Set a Framing
Square inside the roof header and align with MALE Edge of panel.
Adjust the panel so it is square
with the framing square. FASTEN down through top side of
ROOF HEADER into the roof panel
4" away from the MALE edgeusing the #10 tek screw(stay
1inch back from front leg of Roof Header
)…recheck Roof Panel is Square and fasten a second
screw 4 inches away from the FEMALE side
Slide post and beam assembly so the left end of the 3x3 Edge Beam is even with the left female
edge of the roof panel.
RECHECK the roof Panel
is SQUARE
& adjust Edge
Beam to be even to left
FEMALE edge of roof panel
LifeRoom ONE Installation Guide
