fountain mercury Express Cruiser 2005, Инструкция по эксплуатации, техническому обслуживанию и гарантии

Страница: 47 / 92

Leave engine hatch door open before you begin starting procedures.
Familiarize yourself with the dashboard, side panel, gauges, switches
and controls.
Turn on your battery switches to the desired
positions. (Port, (Center), Starboard, 1-2 or All)
Battery Switches are located under the cockpit
sink unit. (“Both” & “Parallel” link all of the batter-
ies in Parallel. This will utilize all of the batteries
for engine starting; however, a single “bad” bat-
tery could cause the others to drain.)
On gasoline powered boats, locate blower toggle switch on left hand
side of dashboard, above the throttle/shifter quadrant. Flip on blower
switch, red indicator light will illuminate. (Blowers are running) Run
blowers for at least five (5) minutes before starting engines. Diesel
powered boats may or may not have engine compartment blowers.
Note: Blowers should be run until vessel is under way.
Make sure shift handles on quadrant
(shifters are the shorter handles) are cen-
tered in the slot, as felt by a detente click.
Note: Engines will not start if the shifters
are not completely in the neutral position.
Make sure the throttle on quadrant (throttles are the taller handles)
are all the way down in the slot. Note: most modern marine engines
are fuel injected, and therefore do
not need to be pumped up and
down to start and idle the motors.
43
Starting, Driving Gauges, Controls
Blower Switch Throttle/Shifter
Quadrant