Foundry ServerIron Hardware Installation Guide
4 - 14
© 2008 Foundry Networks, Inc.
October 2008
information but you cannot configure system or port parameters.
•
Privileged EXEC – This level is also called the Enable level and can be secured by a password. You can
perform tasks such as manage files on the flash module, save the system configuration to flash, and clear
caches at this level.
•
CONFIG – The configuration level. This level lets you configure the system’s IP address and configure
switching and routing features. To access the CONFIG mode, you must already be logged into the Privileged
level of the EXEC mode.
You can set the following levels of Enable passwords:
•
Super User – Allows complete read-and-write access to the system. This is generally for system
administrators and is the only password level that allows you to configure passwords.
NOTE:
You must set a super user password before you can set other types of passwords.
•
Port Configuration – Allows read-and-write access for specific ports but not for global (system-wide)
parameters.
•
Read Only – Allows access to the Privileged EXEC mode and CONFIG mode but only with read access.
To set passwords:
1.
At the opening CLI prompt, enter the following command to change to the Privileged level of the EXEC mode:
FastIron> enable
2.
Access the CONFIG level of the CLI by entering the following command:
FastIron
# configure terminal
FastIron(config)
#
3.
Enter the following command to set the super-user password:
FastIron(config)# enable super-user-password <text>
NOTE:
You must set the super-user password before you can set other types of passwords.
4.
Enter the following commands to set the port configuration and read-only passwords:
FastIron(config)# enable port-config-password <text>
FastIron(config)# enable read-only-password <text>
NOTE:
If you forget your super-user password, see “Recovering a Lost Password” on page 4-14.
Syntax: enable super-user-password | read-only-password | port-config-password <text>
Passwords can be up to 32 characters long.
Recovering a Lost Password
By default, the CLI does not require passwords. However, if someone has configured a password for the device
but the password has been lost, you can regain super-user access to the device using the following procedure.
NOTE:
Recovery from a lost password requires direct access to the serial port and a system reset.
To recover from a lost password:
1.
Start a CLI session over the serial interface to the Foundry device.
2.
Reboot the device.
3.
While the system is booting, before the initial system prompt appears, enter b to enter the boot monitor mode.
