Fostex MR-8MKII, Руководство пользователя

Страница: 38 / 154

38
MR-8mkII Owner’s Manual (Basic recording operations)
<Note>:
The fader for track 1 is used to ad-
just the monitor level. To adjust the record-
ing level, use the [TRIM] control of the [IN-
PUT A] channel.
You can record onto any one of tracks 1 through 4. When making recording to a single track, you
can record a signal fed to the [INPUT A] channel.
The following describes the procedure for recording a guitar sound onto track 1. We assume that
a CompactFlash
TM Card is set to the slot and Song01 is loaded.
1) Connect a guitar to the [UNBAL/GUITAR] phone
jack of the [INPUT A] channel.
2) Set the [INPUT A SELECT] switch to "GUITAR".
3) Press the [REC SELECT] key for track 1.
Preparation for recording
<Note>:
To record an external microphone
or line output signal such as a keyboard
output, set the [INPUT A SELECT] switch to
“MIC/LINE”. To record a built-in micro-
phone sound, set the [INPUT A SELECT]
switch to “INT MIC”. When setting the switch
to “MIC/LINE”, you can use the microphone
simulation effect (see page 60).
4) Set track fader 1 and [MASTER] fader to the
nominal position (marked by
).
Raising these faders allows you to monitor the
input sound. If these faders are not raised, you
cannot monitor the sound via headphones.
Recording onto a single track
MAX
MIN
MAX
MIN
REC SELECT
1 2 3 4 5/6 7/8 MASTER
R L
PAN
L R L R L R
0 10
EFFECT SEND
10 0 10 0 10 0
BRIT STACK US METAL 60'S COMBO
MIC
TUBE CONDENSER DYNAMIC
INPUT A
LINE MIC MIN MAX LINE MIC
DISTORTION
GUITAR
UNBAL
BAL
UNBAL
/GUITAR
PEAK
TRIM TRIM
BAL
INPUT A INPUT B
PHONES VOL
L
ST OUT
R
2
PHONES
1
MIN MAX
EFFECT
REVERB/DELAY TIME
MIN MAX
HALL ROOM
PLATE DELAY
LOCATE REC END
A-B PLAY
LOCATE ABS ZERO
DELETE +-_0 YZ9 VWX8 STU7
PLAY STOP RECORD REWIND F FWD
PQR6
UNDO/REDO PLAY MODE STORE A / IN B / OUT
LOCATE
MNO5 JKL4
BRIGHT NATURAL POWERFUL MENU/ENTER
MASTERING
GHI3 DEF2 ABC1
7/8
WAV FILE
STEREO
1-4
1-6
NEW
SONG
1-8
GUIDE
RHYTHM
CONTRAST
TIME BASE
SELECT
BOUNCE
INPUT A SELECT
AUTO PUNCH
5/6
7/8
AMP SIMULATION
MIC SIMULATION
PEAK
INPUT A SELECT
INT MIC
GUITAR
MIC/LINE
1
2
3
4
5
6
7
8 9
10
6
When recording a guitar sound with the [IN-
PUT A SELECT] switch set to “GUITAR”, you can
use the amplifier simulation effect (see page
60).
Track 1 is record armed and the [REC SELECT]
key for track 1 starts flashing.
On the home screen, the remaining time is
shown, while "1" for the track number changes
to "A".
This indicates that the [INPUT A] channel is
assigned to track 1 and you can now record
the source (guitar) connected to the [INPUT A]
channel.