To adjust the position of the
shelves insert the shelf clip
into the vertical support with
the ‘hook’ pointing upwards
and ‘slot downwards’ into
position. Ensure the shelves
are parallel and level after
fitting.
Shelf/Tray Supports
3
installation
Positioning/unpacking
1
All models are normally fitted
with swivel castors. Ensure
during installation the unit is level
if not the door(s) may not close
correctly. Adjust castors by
inserting spacers under the
appropriate castor and the base
of the unit until level.
Castors/legs/feet
2
IMPORTANT:
To the installer: Installation of these units should be carried out by a competent person and
the appropriate codes of practice adhered to, thus ensuring safe installation.
Pass to the user: Do not discard this document: it contains important guidelines on
Operation, Loading, Cleaning and Maintenance and should be kept for reference.
english
GB
2
Important :
It is not advisable to position the cabinet adjacent to an intense heat source i.e. flame grill, oven,
hob, etc. as this may have an adverse effect on the machine and performance.
Unpacking:
The unit is delivered on a pallet and shrink-wrapped. Documentation is inserted into a clear
pocket located inside the unit. Carefully remove the protective plastic film and cardboard from the
unit exterior and from the door opening surround making sure that any sharp instrument used does not cause
damage, plus remove any quality labels.
Cabinet removal from the pallet:
Cut the plastic ties securing the cabinet to the pallet using a sharp knife
or scissors. Move the unit over the front of the pallet, carefully slide the unit off the pallet until it is stable on
the ground.
Cabinet
castors
DISPOSAL REQUIREMENTS
If not disposed of properly all refrigerators have components that can be
harmful to the environment. All old refrigerators must be disposed of by
appropriately registered and licensed waste contractors, and in accordance
with National laws and regulations.
english
GB
3
If the unit has been laid on its back at any time DO NOT switch on immediately but leave in the upright
position for at least 60 minutes. To switch on the unit see ‘User Operation Guidelines’. Allow the unit to reach its
normal operating temperature before loading with product.
Switching On
4
start up
user operation guidelines
5
Controller
-
Initial Start Up
Your new Foster Cabinet will be delivered ready to run. Plug into the mains supply and the
unit will operate in the following way.
Start Up & Self Test:
The indication is only displayed during the first three seconds
following the mains electrical power being applied to the unit. During this period the
controller performs a self-check.
Once the self-check has been completed will be displayed.
6
Operator Instructions
1. To Start the Unit
Press and hold for three seconds. The unit will start and the air temperature will be displayed.
2. To Check Storage Temperature Set Point
Check set point by pressing the button
Factory Temperature Set Point
Refrig1˚C to +4˚C
Freezer -18˚C to -21˚C.
Exit from set up occurs after 10 seconds if no button is pressed.
3. Manual Defrost
To initiate a manual defrost press and hold will be displayed release.
On completion of the defrost will be displayed until the cabinet temperature is achieved and then it will revert to
displaying the normal cabinet temperature.
4. Set Unit to Standby.
Press display shows (standby indication)
Standby Indication
This indication is displayed while the unit is not operating but with mains power applied to the unit. This mode may be used for inter-
nal cleaning regimes and short periods when the unit is not required.
For extended periods of inactivity the mains supply should be isolated.
OFF
OFF
i set
❄
i set
EF
ee
P
F
❄
❄
❄
❄
