8
FENCING INSTALLATION: EVOLVER
sewerage lines, that may run across them.
You may wish to check that you are not
digging into them.
STEP 2.1
Slide your post over the mount.
STEP 2.2.
Use a screw to fasten your post to your mount.
Installation Guide - 2017 4
Fig. 2
Fig. 3
SECTION
VIEW
TOP VIEW
Line Post Base
Corner Post Base
Step 2:
Mount Post (Not Embedded/Existing Foundation)
1. Slide the Post over the mounted Post Bases.
As shown in Fig. 1.
2.
Be sure to have each fence board slot facing the slot of
the opposite post. As shown in Fig. 2.
3. Use a level to confirm that the post is mounted at
90
o
degree angle.
4. Pre-drill screw holes into Post Base & Post with
a 1/16” [2mm] drill bit.
5. Use a drill to fasten
screws into the post to the mounted
post base. As shown in Fig. 3.
Note:
• Closed wall sides are aesthetically best position for forward
facing posts.
• Post Slide Covers can be used to cover unused fence slots.
Max.
Post Base Spacing is
73” [1860mm ].
Fence Board Width is
70-1/2” [1791mm].
