Fortinet FortiSwitch-548B v. 5.2.0.2, Руководство администратора

Страница: 367 / 969

- 367 -
7.21.2.9 match dstip
This command adds to the specified class definition a match condition based on the destination IP
address of a packet.
Syntax
match dstip <ipaddr> <ipmask>
<ipaddr> specifies an IP address.
< ipmask> specifies an IP address bit mask; note that although similar to a standard subnet mask,
this bit mask need not be contiguous.
Default Setting
None
Command Mode
Class-Map Config
7.21.2.10 match dstl4port
This command adds to the specified class definition a match condition based on the destination layer 4
port of a packet using a single keyword or numeric notation or a numeric range notation.
Syntax
match dstl4port {<portkey> | <0-65535>}
To specify the match condition as a single keyword, the value for < portkey> is one of the supported port
name keywords. The currently supported < portkey> values are: domain, echo, ftp, ftpdata, http,
smtp, snmp, telnet, tftp, www . Each of these translates into its equivalent port number, which is used
as both the start and end of a port range.
To specify the match condition using a numeric notation, one layer 4 port number is required.
The port number is an integer from 0 to 65535.
To specify the match condition using a numeric range notation, two layer 4 port numbers are required
and together they specify a contiguous port range. Each port number is an integer from 0 to 65535, but
with the added requirement that the second number be equal to or greater than the first.
Default Setting
None