To activate or deactivate an option touch
the relevant button or 2 buttons
combination.
When the option is activated, the LED
above the button or symbol illuminates on
the display.
Child lock option
The child lock can be set to prevent
children from playing with the appliance.
The child lock option locks all touch buttons
and the program dial (this option does not
lock the
On/Off (Ein/Aus)
button).
You can activate the child lock option:
• before you touch the
Start/Pause
button - the appliance cannot start
• after you touch the
Start/Pause
button - programs and option selection
is unavailable.
Child lock option activation:
1.
Turn the dryer on.
2.
Select 1 of the available programs.
3.
Touch and hold down 2 buttons at the
same time.
The symbol appears on the display.
4.
To deactivate the child lock, touch the
above buttons again until the symbol
disappears.
Starting a program
To start the program:
Touch the
Start/Pause
button.
The appliance starts and the LED above the
button stops flashing and stays on.
Program change
To change a program:
1.
Push the On/Off (Ein/Aus) button to
turn the appliance off.
2.
Push the On/Off (Ein/Aus) button
again to turn on the appliance.
3.
Set a new program.
Program end
Clean the filter and drain the
water container after each
drying cycle. (See chapter CARE
AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the
Buzzer
(Signal) option is activated, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease phase
starts (not active with all
programs). Flashing symbol
signals the execution of the
anticrease phase. Laundry can
be removed during this phase.
To remove the laundry:
1.
Push the On/Off (Ein/Aus) button for
2 seconds to turn the appliance off.
14
