Operational Information
Starting
Unpowered, turn over the FF2.2, a silk screen legend indicates the position of various additional
controls that are to be preset before use.
Set cartridge capacitance for phono inputs to your preferred setting to best match the cartridge
using a small flat bladed screwdriver, there are 4 settings, through the hole by the legend for
cartridge capacitance the slotted shaft of a switch should be visible, place the screwdriver blade
into the slot and lightly turn to the position you require. If in doubt turn to one end and then count
clicks until you are at position.
If you require rumble filters they are enabled by a switch through the hole by the legend indicting
rumble filter, push the blade of the small flat blade screwdriver through the hole and activate the
switch if you require the rumble filter on, the switch is on when depressed and to switch it off
gently press it again and it will click off. In the off position the switch cap is nearer the case (higher)
and on the switch cap is lower.
If you are using a microphone and it requires phantom power, the phantom power switch is by the
legend phantom power, push the blade of the small flat blade screwdriver through the hole and
activate the switch if you require the phantom power on, the switch is on when depressed and to
switch it off gently press it again and it will click off. In the off position the switch cap is nearer the
case (higher) and on the switch cap is lower.
If you require your mic in the booth signal, the mic in/out of booth switch is by the legend mic
in/out of booth, push the blade of the small flat blade screwdriver through the hole and activate the
switch if you require the mic in the booth (switch on), the switch is on when depressed and to
switch it off gently press it again and it will click off. In the off position the switch cap is nearer the
case (higher) and on the switch cap is lower.
If you require the booth set to mono, the booth mono switch is by the legend booth mono, push
the blade of the small flat blade screwdriver through the hole and activate the switch if you require
booth mono (switch on), the switch is on when depressed and to switch it off gently press it again
and it will click off.
If you require a mono output instead of sub bass, the sub bass/mono switch is by the legend sub
bass or mono, push the blade of the small flat blade screwdriver through the hole and activate the
switch if you require mono (switch on), the switch is on when depressed and to switch it off gently
press it again and it will click off.
If you require the cross fader to be switched off, the cross fader off switch is by the legend X Fade
on/off, push the blade of the small flat blade screwdriver through the hole and set the switch to off
(cap higher), switch is on when depressed (lower) and to switch it off gently press it again and it
will click off.
The remaining presets through the base of the unit require the FF2.2 to be active to set (booth
pan, mic gain and mic EQ), so now return the FF2.2 to correct way up.
8
Содержание FF2.2
Страница 1: ......
