Base Dimension Correction allows for re-calibration without turning off the power, and optional correction of dimension (if
displayed dimension does not correspond to real, measured dimension).
options - base Dimension Correction
When starting the cutter, measure the cut paper and compare that measurement with the on-screen display. If both dimen-
sions do not match, the operator must adjust the base dimension, following these steps:
•
Move the back gauge into position (for example, 11”)
•
Cut the paper
• Measure the size of the cut sheet
• If the measured size is 10.5”, the operator should change the dimension by increasing the value
(difference between screen size and “real” measured size), which would be .5” in this example.
• If the measured size is 11.25”, the operator should change the dimension by decreasing the
value, which would be .25” in this example.
8
To set, choose a language, then press
ReTURn
.
options - language
Eject can be set in inches or mm. It is the value by which the paper stack moves forward at the end of a cycle. After each
cycle, the back gauge returns to the previous position. Enter the value, then press
ReTURn
.
options - special functions, eject
Touch to change the value
Touch to change the value
Touch to exit this mode
Содержание Cut-True 29A
Страница 1: ...Cut True 29A 29H Guillotine Cutters PROGRAMMING MANUAL First Edition 11 2016...
Страница 2: ......
Страница 4: ......