![background image](http://html1.mh-extra.com/html/formax/6304-series/6304-series_operators-manual_2320101017.webp)
15
ENGLIS
H
2. Loosen the knob
B
half a turn.
3. Grab the side guides in the middle and push
them apart as far as possible.
4. Put a small stack of documents between the side
guides.
5. Grab the side guides in the middle and push
them towards the documents.
The space between the side guides and the
documents should be such that the documents
have just enough play to move freely.
6. Re-tighten knob
B
.
7. Remove the stack of documents.
8. Replace the document feeder tray (3.2.1 ”Document Feeder Trays” on page 12).
3.4.3
Document Separation
‘Document separation’ means the adjustment that is required to separate the upper
document from the rest of the documents in the stack. This prevents picking up to
o many
documents from the stack at the same time.
The document separation for the
automatic feeders
is set automatically. There are no
manual adjustments needed.
Feeder 1 (the feeder in lowest position) can be a
special feeder
. You can manually adjust
the separation of special feeders as follows:
1. Remove feeder trays 2 and 3 (the upper trays).
2. Push the knob
B
forward until it clicks.
3. Turn the left-hand side guide
A
downwards.
4. Place a document on the feeder tray and slide it
about 60 mm (2.4 inch) into the system. Turn
the knob
B
counter clockwise if the separation is
set to
o
narrow.
5. Push the document between the separation
rollers, which are behind the rubber paper
pullers.
6. Turn the knob
B
clockwise to increase resistance
or counter clockwise to lower the resistance.
The separation is adjusted correctly when a slight resistance is felt on the document.
7. Pull the knob
B
back again when ready.
8. Close the left-hand side guide.
B
A
B
Содержание 6304 Series
Страница 1: ...6304 Series Inserter OPERATOR MANUAL Rev 1 2010...
Страница 2: ......
Страница 6: ...4 Please use the subjoined return or...