Illustration #2 – Pedestal Installation Diagrams
Illustration #3 – Clip Configuration – Patent No. 6,892,427
11. Peel and fold an anti-abrasion film pad in half over the edge of the hood underneath each of the two (2) inner holes in the protector. See Illustrations
#1 & #3
– Step #11
12. a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in
Illustration #3 – Step #12a
.
b) Insert a pin through the protector into each of the clips,
See Illustration #3 – Step #12b.
c) Insert a #6 x 5/8
’’ screw through an ‘L’- bracket and into the clip.
See Illustration #3 – Step #12c & 12d.
d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.
13.
Repeat steps #11 and #12 for the other two (2) holes.
14.
Tighten the three centre adhesive pedestal assemblies.
15. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
CAUTION: Do not expose the vehicle/hood protector to extreme environments (weather) or car washes for a 24 hour period following the installation to
allow the adhesive pedestals sufficient time to reach full bond strength.
·
Ensure hood surface is clean, dry, and surface temperature is above 15 deg C prior to starting installation
·
Ensure no parts contact headlamps or grill
·
Ensure all clips and fasteners are fully seated and engaged
·
Ensure adhesive pedestals are fully adhered and wetted-out
CARE INSTRUCTIONS
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or
solvents
. Periodically check to make sure the bumpons are in place and the protector is secure.
Avoid using automatic
car washes
. Do not pull on protector when opening or closing the hood.
Thank you for purchasing a
form fit
hood protector. Retain this sheet for care instructions and kit information.
Made in Canada
Rev0.110628
Step #11
Step #12a
Step #12b
Step #12c & 12d
Step #5
Step #5
Step #5
Step #6
Step #7
Step #8
Step #9
Step #10 & 14
