8
3.0. INSTALLATION GUIDE
█ 3.4. ASSEMBLING AND INSTALLING THE WINDOW KIT
Your window kit has been designed to fit most standard vertical and horizontal window, and patio
door applications, however it may be necessary for you to improvise or modify certain aspects of the
installation for certain types of window. Start by measuring the window opening you have available and,
using the table below, determine which slider panels you will be needing.
Panel
Window opening
A
B1
C
B2
65 cm (25 ½ in)
●
65 – 127 cm (24 ⅜ – 50 in)
●
●
127 – 189 cm (24 ⅜ – 74 ⅜ in)
●
●
●
189 – 250 cm (74 ⅜ – 98 ⅜ in)
●
●
●
●
A
B1 B2
C
59
cm (23
1/4 in)
65
cm (25
½ in)
62
cm (24
⅜ in)
59
cm (23
¼ in)
Notes :
▪ If the window opening is less than 65 cm (25
½
in), the minimum length of the panel A, shorten the
panel by cutting off the exceeding length in order to fit the window opening.
▪ Never cut out the hole from panel A.
Assembling the Window Panels
The following instructions covers the assembly of all 4 panels. Adjust as required.
1.
Insert a T-bolt into the end of panel A opposite to the coolant lines opening.
2.
Slide panel B1 onto the end of panel A, making sure the T-bolt is simultaneously inserted onto the
central groove, then use the wing nut and washer to secure both panels together.
3.
Insert a T-bolt into one end of panel C.
4.
Slide panel B1 onto the end of panel C, making sure the T-bolt is simultaneously inserted onto the
central groove, then use the wing nut and washer to secure the sections together.
5.
Insert a T-bolt into the other end of panel C.
6.
Slide panel B2 onto the end of panel C, making sure the T-bolt is simultaneously inserted onto the
central groove, then use the wing nut and washer to secure the sections together.
T-bolt
Hole
FIG. 7 – Insert T-bolt from the back
T-bolt
Central groove
FIG. 8 – Insert into central groove
Wing nut
and washer
FIG. 9 – Secure with wing nut
