Forest SHUTTLE L Z-Wave, Установка

Страница: 9 / 12

9 │ Installing the Forest Shuttle ® S / M / L
Z-Wave
COMMAND_CLASS_ASSOCIATION_GRP_INFO
The Shuttle LZ supports only 1 association group.
Group 1 Name:
-
Size: 8
-
Name: ‘Lifeline’
Group 1 Info
-
Mode: 0
- Profile: 0x0001
o
Main profile : General (0x00)
o
Sub profile : Lifeline (0x01)
- Event Code: 0
Group 1 command list
- List length: 1
- COMMAND_CLASS_SWITCH_MULTILEVEL
NOTE: All other groups report list length 0.
COMMAND_CLASS_SWITCH_BINARY
The Switch Binary command class can be used to turn the Shuttle LZ fully open or fully closed.
Value:
- 0x00: Close
- 0xFF: Open
COMMAND_CLASS_SWITCH_MULTILEVEL_V3
The switch multilevel set command class is used to set the light to a preferred position.
- Values 0 – 99 (%) are used to set the position
- Value 255 is used to set the curtain fully open.
The switch multilevel start level change command is used to start open/close the curtain.
This level change is stopped when
- Stop multilevel start level command is received
- The curtain reached an end position (fully open or full closed)
Supported Report
Because of version 3 of this command class the Shuttle LZ responds with the following types.
- Primary Switch Type: 0x03
o
0xFF is Open
o
0x00 is Closed
- Secondary Switch Type: 0x00
(NOT SUPPORTED)
NOTE 1:
due to the limitations of this type of multilevel, a curtain rail the Duration byte of the SWITCH_MULTILEVEL_SET and
SWITCH_MULTILEVEL_START_LEVEL_CHANGE command is used as an timeout offset to start the changed position
Example 1:
- Curtain rail has position 50%
- Shuttle LZ receives SWITCH_MULTILEVEL_SET command with value 80% and duration 0 seconds.
- The curtain rail is directly moved to position 80%
Example 2:
- Curtain rail has position 50%
- Shuttle LZ receives SWITCH_MULTILEVEL_SET command with value 20% and duration 10 seconds.
- The curtain rail is moved to position 20% after 10 seconds.
NOTE 2: due to the limitations of this type of multilevel, a curtain rail the Start Level byte of the
SWITCH_MULTILEVEL_START_LEVEL_CHANGE command is ignored in all cases.