forest river CENTURY ADA +1, Руководство по эксплуатации

Страница: 15 / 29

Instructions for Lowering and Raising an ADA Unit
1. Position unit on a level and flat area.
2. Located in the mechanical room, there are three (3) switches that control the electrical
jacks that raise and lower the unit.
To lower the unit:
1. Use all three switches to raise the unit so that the axle and tires are off the ground.
2. Remove the pins from both sides of the independent axle system.
3. Use all three switches to lower unit so that it rests completely on the ground.
4. Remove the step(s) from the cube(s) and pin them in place. Adjust leveling feet as
needed.
5. Unbolt and lower the ADA platform. Adjust leveling feet as needed.
6. Remove the ramp sections from the ADA cube. Install ramp sections to the ADA
platform.
7. Install rails for ramp and platform.
To raise the unit:
1. Remove rails, ramps, steps and stow them in their appropriate cube.
2. Raise and bolt the ADA platform in place.
3. Use all three switches to raise the unit completely.
4. Re-insert pins in both sides of the independent axle system.
5. Lower the unit back onto the axle and tires and continue to retract the roadside and
curbside jacks into the full upright and stored position.