Revised September 13, 2013
I.
Measure depth of the fuel tank. Locate this dimension in Column “A’’ of
Table 1. Column “B” shows the length from the underside of the sender
flange to the center of the float pivot. Column “C’’ shows distance from the
center of the float pivot to the center of the float. For example, a tank 12’’
deep would need a measurement of 6’’ from the flange to the pivot and 7.8’’
from the pivot to the float.
II.
For tank depths 6” to 15-1/2’’, it will be necessary to eliminate a part of the
assembly. (See Fig.1) proceed as follows:
1. Remove two screws “d’’ and discard.
2. Remove two screws “e” from the plastic housing and reserve for later us.
3. Carefully remove bracket “f ’’ from the plastic housing and discard.
Replace with bracket “g’’ in the housing and loosely re-install the two
screws “e’’ into housing.
4. Slide housing up or down until the proper dimension from Table 1 is
reached, then tighten screws securely.
CAUTION:
Do not over tighten hardware to avoid damage to the threads.
