Revised September 13, 2013
Nut
Lock Washer
Washer
Signal Wire
Oil Pressure Sender
[SN52]
Ring Terminal
45° Elbow
Entension
Engine Block
Do not use teflon tape on the oil pressure
sender or extension threads because this
interferes with the sender's ground
connection.
To position
6
of circuit board
connector plug.
Figure 1: Oil Pressure Sender Wiring
Signal Wire
Lock Washer
Nut
Washer
Ring Terminal
Intake Manifold
Temperature Sender
To position
7
of circuit board
connector plug.
Do not use teflon tape on the threads of
the sender (except SN12mm) since this
interferes with the sender's ground
connection. SN12mm requires a
copper crush washer to supply a ground
to the sender.
Part Number:
SN25, SN24,
SN23, SN22 or
SN12mm
Figure 2: Temperature Sender Wiring
