Ford 2006 Escape J87R, Руководство по ремонту кузовов

Страница: 13 / 90

GENERAL INFORMATION
00-00–9
00
INSTALLATION PREPARATIONS
id000000600400
Rough Cutting of New Parts
•
For cut-and-join areas, allow for an overlap of
30—50 mm {1.18—1.97 in} with the remaining
area on the body side and then rough-cut the new
parts.
Determination of Welding Method
•
If the total thickness at the area to be welded is 3
mm {0.12 in} or more, use a CO2 gas
shielded-arc welder to make the plug welds.
Making Holes for CO
2
Arc Welding
•
For places that cannot be spot welded, make a hole for CO
2
arc welding using a punch or drill as follows.
(mm {in})
•
Grind the shaded section indicated in the diagram
below and create a hole in the part where the 3—
4 plates are put together. Also, weld the plates
together tightly so that gaps do not develop.
Over lap
Over lap
Body side rough cut location
New part rough cut location
30-50mm{1.18-1.97in}
30-50mm{1.18-1.97in}
acxuub00000048
3mm
{0.12in}or more
acxuub00000049
Panel thickness (ø) Hole diameter (ø)
0.60—0.90 {0.02—0.03} 5 {0.19}
0.91—1.20 {0.04—0.05} 6 {0.23}
1.21—1.80 {0.051—0.07} 8 {0.31}
1.81—4.50 {0.071—0.17} 10 {0.39}
φ
10mm{0.39in}
Outer panel
Middle panel
Inner panel
30
°
30
°
acxuub00000050