ENGLISH
ENGLISH
8
GETTING STARTED
OPERATION
Mounting the tool
For adjustment of the most convenient
working position, the application tool
can be mounted in 45° steps.
1. Unscrew the clamping screw (9).
2. Clean the tool holder (1), the
application tool and the clamping
screw (9).
3. Place the application tool exactly onto
the star-shaped tool accessory holder
(4). Pay attention that the application
tool has a flush fit.
4. Tighten the clamping screw (9) using
the supplied Allen key (10).
Mounting the dust extractor
1. Mount the suction device step by step
as shown in the figures.
2. For connection with a Dustex or
a vacuum cleaner, various hose
adapters are available as an
accessory.
3. To remove the suction device again,
push the clamp at the mark to the rear.
Intended use.
The oscillating movement of your
“multi purpose power tool”has distinct
advantages which no other electric
power tool can offer:
1. No recoil when sanding in corners and
along edges.
2. High cutting performance right into the
corner.
3. Minimum operating noise without
independent movement of power tool.
The oscillating movement transforms
your multi-purpose power tool:
Switching On and Off
First check that the cable and plug are
not damaged.
Switching the power tool ON:
Slide switch(2)forwards (I).
Switching the power tool OFF:
Slide switch (2)backwards(0).
The tools is switched “ON” by the slide
switch located on the topside of the motor
housing.
WARNING! Hold the tool firmly while starting
the tool, since torque from the motor can
cause the tool to twist.
Speed setting
The device is equipped with an electrical
speed adjustor. The adjusting disk is
marked with figures: “1, 2, 3, 4, 5, 6”. You
can increase the speed when you turn to
higher number. To decrease the speed, turn
the adjusting to lower number.
1. Sawing
a) Clean and straight cut, precise to
within a millimeter
b) Can be plunged at any point into
the workpiece
c) Cutting depth automatically
determined.
d) Low dust formation
2. Scraping
a) Minimum effort required.
3. Cutting (blade)
a) Hard and soft materials.
4. Polishing
a) Puts a shine on stone,metal and paint.
