15
16
Remove top beam
a. loosen all four press connector bolts.
b. lift top beam off and place beam on side; do not place beam with platens facing
downward in contact with a surface.
Caution
platen surfaces may be hot.
c. remove top silicone pad and inspect splice. elements of a properly installed endless
splice include:
– Limited but consistent flow of PVC/Urethane material through the splice.
– proper bonding, especially at the tips of the fingers. ‘pin holes’ should not be present
at finger tips.
– Bending of the splice joint should not create any separation at the finger edges.
– No scorching of the belt cover or bottom ply should be evident.
17
Packing press in flight case
a. reassemble top beam onto press, tighten all four press connector bolts, and install
clamp bars on press.
b. Carefully place press in flight case.
c. Close case and engage the locking latches.
18
Maintenance
a. the reading and the application of the advises of this handbook, besides the right
usage of the Blizzard, are the primary premises for the right maintenance and the
conservation of Forbo siegling presses.
b. Forbo siegling suggest a visual checking of all the system each time working with
Blizzard, pressure indicators and electrical connections. the usage of the products is
third people responsibility. Forbo siegling only suggests in this handbook the right
procedures for the people and the equipment safety.
19
Solution to problems
Symptom
Possible solution
no electric inlet
Check the connection to mains
no electric inlet
Check (only technicians) fuses, thermometers
and contactors in the control box.
no pressure
Check pneumatic connections, and compressor.
Wrongly joining
Check that the belt is centred in the plate.
Wrongly joining
the parameters are not right. Check them and
try again to reach the perfect joining to each belt.
thermometer shows. s.err
the connection with the probe
Содержание siegling blizzard HP 160/1000 AIR
